Shenzhen Shengjiahui Technology Co., Ltd.Ryan · +86 134 2323 6661 · ryantools0@gmail.com
← Back to blog
SHENGJIAHUI · ORIGINAL GUIDE

How to Select Micro Drills for Small-Hole Machining

Prepare hole geometry, material and machine details for a useful micro-drill review.

Specify the finished hole

The requested diameter is only the start of a micro-drill brief. Include the hole tolerance, cylindrical depth, blind or through geometry and drawing revision. Show the entry and exit surfaces, cross holes and any interruption. If the component needs a defined bottom profile, make that requirement explicit instead of treating the drill point as an unimportant detail.

Relate depth to chip removal

A deeper hole changes the conditions under which chips and coolant move through the feature. Provide the required depth, available clearance and coolant method. Do not assume a drill with the same diameter but a longer flute is an equivalent substitute. Ask the supplier to review geometry and process requirements together for the proposed tool.

Describe machine and holder conditions

Provide the machine type, spindle range, holder interface and planned tool projection. If you have measured runout, report the value and how it was measured. Avoid inventing a universal runout limit for all drill diameters and setups. The acceptable setup and recommended cutting data should come from the specific tool and application review.

Name the actual workpiece material

Use the material grade and condition, not just a broad term such as metal or plastic. Include hardness or heat treatment when relevant, and identify stacked or mixed materials. If the material or surface changes between batches, mention that variation. A supplier needs these details to discuss the drill material, cutting geometry and coolant approach.

Agree on preparation and inspection

Explain whether the entry surface is prepared and whether the process includes a pilot or spot operation. Follow the proposed drill’s reviewed preparation guidance rather than adding a universal peck or pilot cycle. State how hole diameter, position, burrs and finish are checked. Record the criteria for any trial so the result can be assessed consistently.

Prepare the inquiry

Send SJH the hole drawing, diameter, depth, material grade, machine and holder details, coolant method and quantity. Add the current drill reference and observed issue if replacing a tool. Ryan can use this information to discuss a micro-drill specification. Dimensions, application suitability and any evaluation are confirmed before supply.

General discussion

Share a question about your cutting tool requirements. Please do not post confidential drawings or personal contact information in the message.

Connecting to discussion service…

Comments appear only after review. Email addresses are never shown publicly. We store submission time and a hashed visitor identifier to limit abuse. Please avoid confidential information. Contact Ryan if you need to request correction or removal.

Approved comments

Let’s discuss your next tool.

Prepare your machining requirements in a structured inquiry.

Request a Quote